A Beginner’s Guide To Cleaning A Weapon


If you know exactly where things are when you need them, the fatigue of decisions is drastically reduced. Track with dry spots or mops to remove Rem Oil and dirt. An easy way to avoid damaging your weapon is to use a snake with good gun cleaning solvent by Armory Den caliber. While you want to continue using your cleaning bars, you should use a drill snake to avoid damaging the crown and rifle. The easiest and cheapest way to avoid all of this is to use a universal drill with its cleaning bars.

They also require less work than a solvent-based toothbrush. An air compressor is also very useful, especially for firearms with earthy matter. When it comes to the hole, a pole, brush, stain, solvent and hard work are required. Semiauto pistols consist of five main components; the frame, the sledge, the barrel, the recoil spring group and the loader. The barrel and the magazine will be handled at a later date in the cleaning process. Rub any corner, surface and feather until the rag has no dust residues.

The Semiauto AR and AK rifle screws and girders are cleaned similarly to a rifle bolt. Simply use a rag that rubs every corner and surface until there are no more residues. Take a bamboo skewer or plastic scraping tool to remove gunpowder residues around the firing pin.

Be an essential maintenance step, clean it after shooting in the field, in a competition, while hunting or at work. By thoroughly cleaning your weapon after use, you can avoid rust, keep your weapon in excellent condition and avoid malfunctions in the operation. Once you have safely disarmed the weapon, start cleaning the barrel.

And when you’re at it, you get a second set so you don’t have to switch between brushes, patch holders, and pug from side to side. I also like to use perforated snakes, so I don’t have to carry as many stains that shorten the cleaning time. Hold down a few small stainless steel trays to hold the parts inside while your weapon is decomposing or to let them soak with solvent. The drilling brushes must correspond to the diameter of the hole. They are available with nylon, bronze or steel bristles.

In step 1 you will learn how to properly clean your weapons. Next you need cleaning bars, preferably coated with nylon, to clean the barrels. There are options for practically every measurement run that you can configure for patches and brushes. Find one of the robust constructions so that it does not bend and has the possibility to dig the rifle into your barrel.

First replace the prong in your cleaning rod… Proper care and maintenance of your firearms ensures that they are ready for use when needed. Consider investing in a barrel snake and / or ultrasonic cleaner. Like everything else, weapon cleaning technology is up to date. For rifles and shotguns, treadmills are long multi-purpose cleaners that make work much faster and easier.

Choose the appropriate size to clean Jag & Attach Patch. You can use a pro-shot plaster holder or a pointed spear clamp of a certain size if you use cleaning plaster to saturate the barrel. Once the weapon has been cleaned thoroughly, it is time to put it back together. Add a small amount of fat to the parts of the metallurgy: the ankle, the kicks and the front loop. Then put the barrels back in action and connect the front end. A final cleaning with our fabric and weapon is well cleaned and stored until next season.

However, it is helpful to keep your rifle in place and not to worry about it moving throughout the cleaning process. I have been using a Tipton weapon press for years. First, put the safety of firearms above everything.